[ros-dev] RE: [ros-kernel] BootCD doesn't boot...

[Royce Mitchell III]

With the bootcd you need to add /DEBUGPORT=SCREEN and possibly 
/DEBUGPORT=COM1, too, and configure VMWare to dump serial to a file. 
Otherwise, you won't see the extra details from the change in io/arcname.c
Richard Campbell wrote:

> Same result, different addresses, see screen
> Hartmut Birr wrote:
>
>> Hi,
>>
>> can you disable line #32 (#define NDEBUG)in ntoskrnl\io\arcname.c and 
>> try it
>> again?
>>
>> - Hartmut
>>
>>  
>>
>>> -----Original Message-----
>>> From: ros-kernel-bounces at reactos.com 
>>> [mailto:ros-kernel-bounces at reactos.com] On Behalf Of Richard Campbell
>>> Sent: Tuesday, September 28, 2004 7:34 PM
>>> To: ros-kernel at reactos.com
>>> Subject: [ros-kernel] BootCD doesn't boot...
>>>
>>>
>>> Hello all
>>>
>>> I'm using a fresh CVS checkout and ROS fails to boot in either 
>>> VMWare or QEMU via the iso built by mingw32-make bootcd.
>>>
>>> Attached is a screen.
>>>
>>>   
>>
>>
>>
>> _______________________________________________
>> Ros-dev mailing list
>> Ros-dev at reactos.com
>> http://reactos.com:8080/mailman/listinfo/ros-dev
>>
>>  
>>
>
>
> ------------------------------------------------------------------------
>
>------------------------------------------------------------------------
>
>_______________________________________________
>Ros-dev mailing list
>Ros-dev at reactos.com
>http://reactos.com:8080/mailman/listinfo/ros-dev
>


-- 
------------------------
http://wecanstopspam.org